Part Number - N008-026A Laboratory Drawdown Jr. Part Number - N008-005 DRAWDOWN :BAR# SELECT ROD DIA either 1/4 inch, 1/2 inch or 3/8 inch >62: Standard Lab Rods with a Rod diameter of 1/4' is not recommended above 62 For example the number 3 rod would be 3 x 2.54 = 7.62 Microns.ДЁ2-90: Standard Lab Rods Only (Accu-Lab Jr. The number 20 rod would be 20 x 0.10 = 2.0 Mils.ДЇor Microns, multiply rod number by 2.54. For example, the number 3 rod would be 3 x 0.10 = 0.30 Mils. To determine approximate wet film thickness in Mils for a specific rod number from the table below, multiply the rod number by 0.10. While the Drawdown charts are used to examine industrial. Standard Lab Rods (N008-056, N008-057 & N008-058) are less expensive due to a different manufacturing process and all of these are 16' long with a centred wound length of 12'. Drawdown charts and Drawdown cards are equally used to quality control of the paint properties. Selection of test charts dependent on coating technology: Depending on the type of solvent used in paint formulations. Stringent equality control during the production. Part Number - N008-026A Laboratory Drawdown Jr. We offer a wide range of drawdown cards and charts for virtually any application and coating material. Drawdown cards usually measure 8 inches by 11 inches and are made by. The glass drawdown plate can acco-modate up to 10 x 16 inch charts (GDP-1) or 7 x 20 inch scrub test panels (DP-3). The vacuum plate supports up to a 9 x 12 inch (227 x 305 mm) chart. Part Number - N008-026 Laboratory Drawdown Jr. A drawdown is a sample of paint from the actual color and sheen specified for the job. drawdown plates including solid with spring clip, rubber feet and a vacuum plate. They are still called 'Mayer Bars' by many coaters. Wire-wound rods were first used in coating machines built by Charles Mayer in the 1900's to manufacture waxed paper and carbon paper. Although the technology goes back almost a century, today's high quality materials, multi-wire designs and special wire surfaces have made this system more popular than ever before. The market for wire-wound rods has grown rapidly during the past few decades, because they provide predictable, accurate coatings time after time, at a minimal cost. Rod selection tables allow coaters to consider coat weight and percent of solids in choosing the proper rod size for each production run.Д«ottom-line profits have encouraged many coaters to modify existing machines, in order to take advantage of the flexibility, the ease of use and the dollar savings associated with rod coating. Wet coating thickness can be accurately predicted within one tenth of a mil (.0001'). These stainless steel rods are 4' shorter than conventional lab rods and offer an additional savings.

Laboratory Drawdown Rods (N008-026, N008-026A) are designed for users producing test samples up to 8ВЅ' wide.

With an overall length of 16', these rods are longer than the Jr. Drawdown Rods, Drawdown Bars, (also known as Mayer Bars)Дrawdown rods give users the ability to fine-tune coating thickness quickly and easily, without altering the chemistry of their coating material, and without time-consuming and expensive changeovers.ДЇor users that require a coating path of up to 12', use the standard Laboratory Drawdown Rods (N008-005 choose 1/4', 3/8', or 1/2').

Paint drawdown cards